Braking Resistor / Supply Voltage C3H; Connect Braking Resistor C3H; Power Supply Voltage Dc C3H - Parker Compax3 Operating Instructions Manual

Parker EME
3.6.8.

Braking resistor / supply voltage C3H

The energy generated during braking operation is absorbed by the Compax3
storage capacity.
If this capacity is too small, the braking energy must be drained via a braking
resistor.
3.6.8.1

Connect braking resistor C3H

Connection of braking resistor - figure (see on page 53)
PIN Designation
DBR+ + Braking resistor
DBR- - Braking resistor
Braking operation of Compax3HxxxV4
Controller type
Capacitance / storable energy
400V / 480V
Minimum braking- resistance
Maximum continuous current
Minimum line cross section:
Maximum line length:
Maximum output voltage:
3.6.8.2

Power supply voltage DC C3H

Connection of power voltage DC -figure (see on page 53)
PIN Description
DC+ + DC high voltage supply
DC- - DC high voltage supply
Warning!
Do not connect any braking resistor on DC+/DC- .
192-120113 N08 C3I12T11 - December 2010
H050V4 H090V4
2600 µF 3150 µF
602 / 419 Ws 729 / 507 Ws
24 Ω 15 Ω
11 A 17 A
2
2.5mm
2m
830VDC
Compax3 device description
H125V4 H155V4
5000 µF 5000 µF
1158 / 806 Ws 1158 / 806 Ws
8 Ω 8 Ω
31 A 31 A
59