Tips - Parker Compax3 Operating Instructions Manual

Setting up Compax3
246
4.4.7.4

Tips

Tip Problem
1 Speed too low
(with reverse operation)
2 Speed too low
(with continuous operation)
3 Test movement missing
4 No error detected
5 Speed too low and amplitude of
the excitation signal too small
(with reverse operation)
Speed too low and

6
amplitude of the excitation

signal too small
(with continuous operation)
Test movement missing
7 
amplitude of the excitation

signal too small
8 amplitude of the excitation
signal too small
9 Following error occurred
*if the travel range is too short, the speed is not increased, as the drive does not
reach the maximum speed.
192-120113 N08 C3I12T11 - December 2010
Measures
Increase maximum speed and adapt travel
range*
Increase maximum speed
A test movement is important for drives with
high friction or with mechanical slack points
(play).
Please note the boundary conditions (see
on page 244).
Increase amplitude of the excitation signal;
increase maximum speed and adapt travel
range*
Increase amplitude of the excitation signal;
increase maximum speed.
Increase amplitude of the excitation signal

or / and
activate an appropriate test movement

Increase the amplitude of the excitation
signal.
Increase the parameter "permissible
following error" or decrease the amplitude of
the excitation signal.
C3I12T11