Conditions Of Utilization For Ul Certification Compax3S - Parker Compax3 Operating Instructions Manual

Introduction
1.7.2.

Conditions of utilization for UL certification Compax3S

22
UL certification for Compax3S
conform to UL:
Certified
The UL certification is documented by a "UL" logo on the
device (type specification plate).
Conditions of utilization
The devices are only to be installed in a degree of contamination 2 environment

(maximum).
The devices must be appropriately protected (e.g. by a switching cabinet).

The X2 terminals are not suitable for field wiring.

Tightening torque of the field wiring terminals ( green Phoenix plugs)

C3S0xxV2

C3S1xxV2,

C3S0xxV4, C3S150V4
C3S300V4

Temperature rating of field installed conductors shall be at least 60°C Use copper

lines only
Please use the cables described in the accessories chapter (see on page 323,
see on page 324), they feature a temperature rating of at least 60°C.
Maximum Surrounding Air Temperature: 45°C.

Suitable for use on a circuit capable of delivering not more than 5000 rms

symmetrical amperes and 480 volts maximum.
ATTENTION
Danger of electric shock.
Discharge time of the bus condenser is 10 minutes.
The drive provides internal motor overload protection.

This must be set so that 200% of the motor nominal current are not exceeded.
Cable cross-sections

Mains input: corresponding to the recommended fuses.

Motor cable: corresponding to the Nominal output currents (see on page 375,

see on page 376)
Maximum cross-section limited by the terminals mm

C3S0xxV2

C3S1xxV2,

C3S0xxV4, C3S150V4
C3S300V4

Circuit breaker

In addition to the main circuit breaker, the devices must be equipped with a S271
K or S273 K circuit breaker with K characteristic made by ABB.
C3S025V2: ABB, nom 480V 10A, 6kA

C3S063V2: ABB, nom 480V, 16A, 6kA

C3S100V2: ABB, nom 480V, 16A, 6kA

C3S150V2: ABB, nom 480V, 20A, 6kA

C3S015V4: ABB, nom 480V, 6A, 6kA

C3S038V4: ABB, nom 480V, 10A, 6kA

C3S075V4: ABB, nom 480V, 16A, 6kA

C3S150V4: ABB, nom 480V, 20A, 6kA

C3S300V4: ABB, nom 480V, 25A, 6kA

192-120113 N08 C3I12T11 - December 2010
according to UL508C

E-File_No.: E235342

"UL" logo:
0.57 - 0.79Nm
0.57 - 0.79Nm
1.25 - 1.7Nm
2
/ AWG
2
2.5mm AWG 12
2
4.0mm AWG 10
2
6.0mm AWG 7
C3I12T11
5 - 7Lb.in
5 - 7Lb.in
11 - 15Lb.in