Installation Enable Of The Servosignalanalyzer - Parker Compax3 Operating Instructions Manual

Parker EME
Please observe:
4.4.9.3

Installation enable of the ServoSignalAnalyzer

In this chapter you can read about:
Prerequisites ................................................................................................................. 251
Installation ..................................................................................................................... 251
Activation....................................................................................................................... 251
Prerequisites
Compax3 with up-to-date controller board (CTP 17)

Firmware version R06-0 installed

Installation
Execution of the C3 ServoManager Setup (on CD)

If the firmware is too old => update with the aid of the firmware from the CD

Activation
In order to being able to use the analysis functions in the frequency range (for
example frequency response measurement), a software activation is required.
The activation is only valid for the PC on which it was performed!
Caution!: If the PC disposes of network adapters which are removed at times (e.g.
PCMIA cards or notebook docking stations), these adapters should be removed
before generating the key!
In order to activate the ServoSignalAnalyzer, please follow these steps:
Start the Compax3 ServoManager.

192-120113 N08 C3I12T11 - December 2010
Setting up Compax3
251