Warranty Conditions - Parker Compax3 Operating Instructions Manual

Introduction
Please note in the
event of storage >1
year:
1.6

Warranty conditions

18
Forming the capacitors
Forming the capacitors only required with 400VAC axis controllers and PSUP
If the device was stored longer than one year, the intermediate capacitors must be
re-formed!
Forming sequence:
Remove all electric connections

Supply the device with 230VAC single phase for 30 minutes

via the L1 and L2 terminals on the device or

multi axis devices via L1 and L2 on the PSUP mains module

The device must not be opened.

Do not make any modifications to the device, except for those described in the

manual.
Make connections to the inputs, outputs and interfaces only in the manner

described in the manual.
Fix the devices according to the mounting instructions (see on page 68, see on

page 74).
We cannot provide any guarantee for other mounting methods.
Note on exchange of options
Device options must be exchanged in the factory to ensure hardware and software
compatibility.
When installing the device, make sure the heat dissipators of the device receive

sufficient air and respect the recommended mounting distances of the devices
with integrated ventilator fans in order to ensure free circulation of the cooling air.
Make sure that the mounting plate is not exposed to external temperature

influences.
192-120113 N08 C3I12T11 - December 2010
mains module
C3I12T11