Mode 2: Compax3 Input Values Are Deduced From Times And Maximum Values - Parker Compax3 Operating Instructions Manual

Setting up Compax3
286
4.4.10.2 Mode 2: Compax3 input values are deduced from
times and maximum values
A jerk-limited motion profile is calculated from the positioning time and the

maximum speed / acceleration
As a result you will get, besides a graphical display, the following characteristic

values of the profile:
the parameters Position, Speed, Acceleration, Deceleration, Acceleration Jerk

and Deceleration Jerk
Times for the acceleration, deceleration and constant phase

Maximum values for acceleration, deceleration and speed

Set deceleration and acceleration phase
The profile can be defined more exactly by entering the segmentation into
deceleration and acceleration phase.
When setting 50% and 50%, a symmetrical design will result, the values for
triangular operation are calculated, which is limited by the maximum speed.
The total of the percentage values may not exceed 100.
The percentage entries refer to the total positioning time.
Example:
35%
192-120113 N08 C3I12T11 - December 2010
30%
100%
C3I12T11