Display On The Viewfinder Screen Of The Bvp-900/900P; Mark Display - Sony BVP-900 Series System Manual

6-1 Display on the Viewfinder Screen of the
BVP-900/900P

6-1-1 Mark Display

On a viewfinder screen, several marks, such as a box
cursor or center marker, can be displayed. The
switches and buttons on the rear of the BVP-900/900P
are to select whether the marks are to be displayed or
to adjust the size of the mark.
CURSOR controls
STORE button
R G B RET
POWER
2 3 4
FILTER LOCAL H-POSI V-POSI
1 5
ND
B C D WIDTH HEIGHT
STORE
A
E
CC
CENTER SAFETY
VF DETAIL
ZONE UP TALLY MIX VF DISPLAY MENU SELECT
MARKER
ON ON ON ON ON
ON
OFF
CANCEL ENTER
OFF OFF OFF OFF MENU OFF
SAFETY ZONE switch
CENTER MARKER switch
Rear of the BVP-900/900P
Box cursor
If you press and light the CURSOR ON button, a box
cursor appears on the viewfinder screen. Press the
button again and the cursor disappears. You can adjust
the size and displayed position of the cursor.
Viewfinder screen
Box cursor
Adjusting the size of the box cursor
Adjust the width of the cursor with the WIDTH
control, and the height with the HEIGHT control.
Adjusting the position of the box cursor
Adjust the vertical position of the cursor on the
viewfinder with the V-POSI control, and the horizontal
position with the H-POSI control.
RET 1
RETURN
1
SELECT
2 3
1
4
CURSOR ON
CURSOR
button
1 2 3 ON
PinP
CURSOR 1–3
POSITION
buttons
ON CALL
OFF
To store the adjusted size and position of the
box cursor
You can store the size and position of the box cursor
adjusted with the H-POSI, V-POSI, WIDTH, and
HEIGHT controls. Three kinds of settings can be
stored, which can be retrieved at any time with the
press of a button.
1
Press the CURSOR ON button.
The box cursor appears on the viewfinder screen.
2
Adjust the size and position of the cursor with the
H-POSI, V-POSI, WIDTH, and HEIGHT controls.
3
Press the STORE button.
4
Press one of the CURSOR 1 through 3 buttons.
The size and position adjusted in step 2 are then
stored in the memory corresponding to the pressed
button.
To retrieve the stored box cursor
Press one of the CURSOR 1 through 3 buttons. The
pressed button lights, and the cursor stored in the
memory corresponding to the pressed button appears.
Note
When one of the CURSOR 1 through 3 buttons is lit,
you cannot adjust the size and position of the cursor.
To make the adjustments, press the lit button to make
it go dark.
Center marker
Set the CENTER MARKER switch to ON. White
cross hairs, which indicate the center of the viewfinder,
appear on the viewfinder screen.
You can adjust the displayed position of the center
marker on the VF Setup 2 display. The adjusted
position can be stored in the lens file.
For details, see "6-1-3 Operation Menu."
Center marker
6-1
Chapter 6 Display