Settings For Stand-Alone Use; Notes On Stand-Alone Use - Sony BVP-900 Series System Manual

Video camera system
Hide thumbs Also See for BVP-900 Series:
Table of Contents

Advertisement

7-5 Stand-Alone Use of the VCS-700

7-5-2 Settings for Stand-Alone Use

To enable the control via the I/O PORT
connector
Set the MODE switch S4-5 on the internal board to
ON. This enables signal switching from the device
connected to the I/O PORT connector on the rear
panel.
To display the signal on a waveform monitor
in sequential mode
Set the MODE switch S4-6 to OFF. This enables
three-wave display of channels 4 to 6 in sequential
mode via pin 26 of the I/O PORT connector. You can
select four-wave display by changing the switch
setting on the component side of an internal board.
For four-wave display, consult Your Sony service
representative.
Note
To display in sequential mode, be sure to connect the
WF MODE connector on the rear to the WF MODE
connector of the waveform monitor.
7-20
Chapter 7 Stand-Alone Operations of Cameras, etc.
PIX
STAIR STEP
CONTROL
1
2
3
4
5
6
POWER
MODE
LEVEL
-15V-5V +5V +15V
POSITION
PRESET
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
CHROMA
CHROMA
CHROMA
CHROMA
CHROMA
CHROMA
MODE switch

7-5-3 Notes on Stand-Alone Use

When using the VCS-700 as a stand-alone unit, note
the following.
• Do not connect any equipment to the REMOTE
connector on the rear.
• The VCS-700 detects and uses the sync signal of the
output signal from the PIX A OUT connector for
internal synchronization. Therefore, always supply a
signal to one of the PIX 1 to 6 INPUT connectors.
If a signal cannot be supplied to any of the PIX 1 to
6 INPUT connectors, supply a sync signal to the
CHARACTER connector.
• When using the VCS-700 in a camera system after
using it independently, connect pin 10 of the I/O
PORT connector to GND and reset the control.
• When disconnecting a device connected to the
I/O PORT connector immediately after using
sequential mode, cancel sequential mode by
connecting any of pins 1 to 6 of the I/O PORT
connector to GND.
WFM
B OUT
B OUT
1
2
3
4
5
6
FINE
FINE
OFF
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
OFF
LEVEL
50
100
CHROMA
CHROMA
CHROMA
CHROMA
CHROMA
CHROMA
CHROMA
50
100
CHROMA

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bvp-900pBvp-950Bvp-950p

Table of Contents