Selecting The Aspect Ratio; Setting The Character Display Of The Cnu-700 - Sony BVP-900 Series System Manual

3-2 Setting and Adjusting on Setup

3-2-8 Selecting the Aspect Ratio

The BVP-900/900P/950/950P operates on the aspect
ratio of 4:3 or 16:9. The used aspect ratio is set with
either of the following two methods.
Method 1
Attach the RC board supplied with the OHB-700-
series CCD unit whose aspect ration is 16:9 to the PR/
DA board of the camera.
If the software version of the AT board of the CCU-
700A/700AP is after 2.00, you can set the aspect ratio
via pin 12 and pin 13 of the MIC REMOTE connector
on the rear of the camera as shown in the table below.
Signal level
pin 12 (activating pin 13)
pin 13 (selecting the aspect ratio)
If the version is 1.xx, consult your Sony service
representative.
For attaching the RC board, see "2-1-1 Mounting the BVP-
900/900P" or "2-1-2 Mounting the BVP-950/950P."
Method 2
Use the ARU-701 and ARU-702 Aspect Ratio
Converter Unit.
For details, refer to the operating instructions supplied with
the ARU-701 and ARU-702.
3-60
Chapter 3 Initial Settings
You can link the camera number displayed on pages 9
and 11 of the character display of the CNU-700 with
the selection of the camera on the MSU-700A/750.
Use the switches on the internal board as shown below
for setting.
Low High
ON OFF
1
16:9 4:3
2
3
4
5
3-2-9 Setting the Character
Display of the CNU-700
AT MODE
+5
UP DOWN SET CANCEL
AT board of the CNU-700
Set the MODE switch to 5.
"INTERNAL MODE SETTING" appears on the
character monitor screen.
Flip the SET/CANCEL switch to SET.
The INTERNAL MODE SETTING display
appears.
INTERNAL MODE SETTING
OFF Page 9, 11 – Link cansel
OFF
OFF
OFF
OFF
OFF
Select "Page 9, 11-Link cancel" with the UP/
DOWN switch.
Flip the SET/CANCEL switch to SET to change
the setting to ON.
Each time you flip the SET/CANCEL switch to
SET, ON and OFF settings are toggled.
Set the MODE switch to 0.
CHARACTER
PHASE
SET/CANCEL switch
UP/DOWN switch
MODE switch