Mounting The Bvp-950/950P - Sony BVP-900 Series System Manual

2-1-2 Mounting the BVP-950/950P

Mounting the CCD unit
The BVP-950/950P is used in conjunction with one of
four different CCD units (OHB-730/730P, OHB-
730WS/730WSP, OHB-750A/750AP or OHB-
750WSA/750WSAP), depending on the purpose.
1
Remove the red connector cover from the rear of
the CCD unit.
2
Loosen two screws on the front panel, and remove
the front panel.
3
Insert the CCD unit, and secure it with the four
mounting screws.
Fasten the screws securely with a screwdriver or
similar tool.
S
Po we r
HA D
S
Po we r
HA D
10 00
10 00
Mounting the RC Board
When the RC (aspect ratio converter) board supplied
with the OHB-730WS/730WSP/750WSA/750WSAP
is mounted in a BVP-950/950P video camera, the
aspect ratio conversion function (from 16:9 to 4:3) can
be applied.
1
Open the side panel of a BVP-950/950P video
camera, and pull the PR/DA boards out.
PR/DA board
2
Remove the CN-1566 board attached to the DA
board by loosening the two screws.
PR/DA board
3
Mount the RC board to the DA board in place of
the CN-1566 board, and secure it with the original
two screws.
PR/DA board
4
Return the PR/DA board to its original position,
and close the side panel.
CN-1566 board
RC board
2-9
Chapter 2 Setup