Sony BVP-900 Series System Manual page 148

Adjusting using the MSU-700A/750
Proceed as follows.
MODE
MULTI
CARD
CONFIG
MAINTENANCE
FILE
PAINT
MAINTENANCE button
Menu operation block of the MSU-700A/750
1
Set the REMOTE/LOCAL switch on the VA board
of the CCU to REMOTE.
2
Press the MAINTENANCE button in the MODE
block of the MSU-700A/750.
The Maintenance Menu appears.
Maintenance Menu
CAM SW
Adjusting
Setting Setup
Lens VCS
Adjusting Adjusting
3
Press [Adjusting].
The Maintenance adjusting item menu appears.
Clear
VBS Camera
Phase
Level Output
Black
White
Shading BlackSet
Shading
Control knobs
Auto
Exit
SDI
Output
1
1
OHB
Matrix
4
Press [Phase] to set it in inverse video.
The lower half of the display becomes the Phase
control display. There are two Phase control
displays for SC and H, which can be selected on
the submenu.
5
Press [SC] to set it in inverse video to turn on SC
Phase control mode.
The lower half of the display becomes the SC
Phase display.
SC Phase
H SC
6
Adjust the phase of SC or BF with the two right
control knobs.
SC: To adjust the SC phase
BF: To adjust the phase of a burst signal of the
encoded output signal
7
Press [H] to set it in inverse video to turn on H
Phase control mode.
The lower half of the display becomes the H Phase
display.
H Phase
H SC
8
Adjust the phase with two right control knobs.
Coarse: To roughly adjust the H phase
Fine: To precisely adjust the H phase and SC-H
phase
To terminate the adjustment
Press the MAINTENANCE button to make it
distinguish.
SC BF
0 0
Coarse Fine
0 0
3-67
Chapter 3 Initial Settings