Selecting And Adjusting The Signal On A Picture Monitor - Sony BVP-900 Series System Manual

• The waveform-monitor control signal is output from
the VCS-700 synchronizing with the output signal of
the WF 2 connector on the CCU-700A/700AP or the
WF connector on the CCU-550A/550AP when the
SEQ button of the WAVEFORM MONITOR
buttons of the MSU-700A is pressed or when the
SEQ button of the MSU-750 is pressed after the
MONITOR WF button being pressed.
• The waveform-monitor control signal is output from
the CCU-700A/700AP/550A/550AP synchronizing
with the output signal of the WF 1 connector on the
CCU-700A/700AP or the WF connector on the
CCU-550A/550AP when the SEQ button of the
WAVEFORM MONITOR buttons of the RCP-700-
series unit is pressed.
Note
Control of sequential mode depends on the waveform
monitor. If necessary, you can reverse the direction of
the control signal with a switch on an internal board as
follows:
VA board of the CCU-700A/700AP: S1102
VA board of the CCU-550A/550AP: S901
VSW board of the VCS-700: S8
If the adjustment is impossible with the direction
reversed, adjust on the waveform monitor.
For further details, refer to the Maintenance Manual
supplied with the VCS-700 and the Operation Manuals
supplied with the VCS-700 and waveform monitor.
3-3-7 Selecting and Adjusting the
Signal on a Picture Monitor
When an MSU-700A/750, CNU-700/500 and VCS-
700 are used in a system, you can monitor the video
output signal on a monitor connected to the PIX A
OUTPUT or PIX B OUTPUT connector on the VCS-
700. Connect the PIX 2 connector of the CCU-700A/
700AP or the PIX connector on the CCU-550A/550AP
to one of the PIX 1 through 6 connectors on the VCS-
700, and check and adjust the signal using a color-bar
signal.
Note
When two CNU-700s are used in a system, up to four
MSU-700A/750 can be connected in the system. In
this case, the signal of the camera corresponding to the
camera select button on the MSU-700A/750 pressed
last is output to the picture monitor.
3-83
Chapter 3 Initial Settings