Control System Of The Cnu-700/500 - Sony BVP-900 Series System Manual

1-2-9 Control System of the CNU-700/500

The CNU-700/500 Camera Command Network Unit
switches the commands sent from multiple
RCP-700-series Remote Control Panels or the MSU-
700A/750 Master Setup Unit and sends them to
multiple BVP-900-series Video Cameras. With the
factory settings, the commands are transmitted from
the RCP-700-series unit to the BVP-900-series
cameras connected to the same numbered connectors
on the CNU-700/500. For example, the RCP-700-
Example of the combination of six video cameras and six remote control panels
The combination of the video cameras and remote
control panels can be changed with the switch on the
AT board of the CNU-700 or with the MSU-700A/
750.
Note
When the CNU-500 is used, the combination of the
RCP-700-series units and BVP-900-series camera
cannot be changed.
BVP-900-series
video camera
1
2
3
4
5
6
CCU-700A/700AP/
CNU-700/500
550A/550AP
CCU1
CCU2
CCU3
CCU4
CCU5
CCU6
RCP-700-series units
Factory setting
series unit connected to the RCP 1 connector sends the
commands to the BVP-900-series camera through the
CCU-700A/700AP connected to the CCU 1 connector.
You can change the combination of the RCP-700-
series units and BVP-900-series cameras on the CNU-
700 using the MSU-700A/750. Several examples of
switching of commands by the CNU-700 are
introduced here.
Factory setting
Control unit Controlled unit
RCP-1 ——— CCU-1 (for Camera 1)
RCP-2 ——— CCU-2 (for Camera 2)
RCP-3 ——— CCU-3 (for Camera 3)
RCP-4 ——— CCU-4 (for Camera 4)
RCP-5 ——— CCU-5 (for Camera 5)
RCP-6 ——— CCU-6 (for Camera 6)
On the display of the RCP-700-series
unit, the camera number controlled
with the unit is displayed.
VCS-700
VCS1
MSU-700A/750
MSU1
1-13
Chapter 1 Introduction