Changing The Registered Lens - Sony BVP-900 Series System Manual
Video camera system
Hide thumbs
Also See for BVP-900 Series:
- Product information manual (140 pages) ,
- Maintenance manual (520 pages) ,
- Operation manual (48 pages)
Table of Contents
Advertisement
5-4-3 Changing the Registered
Lens
When using a lens other than the registered in lens
files, change the lens name of a file.
To change a file of the BVP-900/900P
1
While holding the MENU SELECT switch toward
ENTER, set the DISPLAY switch to MENU to
display the Maintenance menu (page 5-17).
2
Turn the MENU SELECT knob to set the cursor to
"Lens File Store," then press the MENU SELECT
switch toward ENTER.
The Lens File Setup menu appears.
Lens File Setup menu
* Lens File Setup *
Lens File Store
Select Current Lens
Reset All Lens
Name :J20x7.5
No:1
EX
Lens selection area
3
Turn the MENU SELECT knob to set the cursor to
"Select Current Lens," then press the MENU
SELECT switch toward ENTER.
The cursor appears in the lens selection area.
4
Turn the MENU SELECT knob to scan the lens
names specified for No. 0 through 49.
5
When the name of the mounted lens appears, press
the MENU SELECT switch toward ENTER.
6
Press the MENU SELECT switch to CANCEL to
return to the Maintenance menu.
To operate on the BVP-700/700P upgraded with
the BKP-7090/7090P
The camera can use the same menus as those of the
BVP-900/900P while the panel configuration differs.
For the operation on the BVP-700/700P, see "7-2-8
Adjustments of the BVP-700/700P Upgraded With the BKP-
7090/7090P."
F1.4
To change a file of the BVP-950/950P
Note
When the camera is installed in the CA-905F/905K,
use the rear control panel of the CA-905F/905K and
operate in the same manner as described for the BVP-
900/900P in the previous paragraph.
1
While holding the ENTER/CANCEL switch
upward to ENTER, set the DISPLAY switch to
MENU to display the Maintenance menu (page
5-18).
2
Set the cursor to "Lens File Store" by turning the
MIC1 LEVEL control, then press the control.
The Lens File Setup menu appears.
Lens File Setup menu
* Lens File Setup *
Lens File Store
Select Current Lens
Reset All Lens
Name :AB.5x5.5
No:1
EX1.0
Lens selection area
3
Set the cursor to "Select Current Lens" by turning
the MIC1 LEVEL control, then press the control.
The cursor appears in the lens selection area.
4
Turn the MIC1 LEVEL control to scan the lens
names specified for No. 0 through 49.
5
When the name of the mounted lens appears, press
the MIC1 LEVEL control.
6
Press the ENTER/CANCEL switch downward to
CANCEL to return to the Maintenance menu.
F1.7
5-19
Chapter 5 File Operations
Advertisement
Table of Contents
