Viewfinder Screen Status Display; Organization Of Viewfinder Screen Status Display - Sony MEMORY STICK HDC-950 Operation Manual

4-4 Viewfinder Screen Status Display

Besides the video image, the viewfinder can display
text and messages showing the camera settings and
operation status, as well as items such as a center
marker or safety zone marker.
When the DISPLAY switch is set to ON, items set to
ON using the VF DISPLAY page of the OPERATION
menu or related switches will be displayed on the
upper and lower edges of the screen. Also, messages
informing of setting values or adjustment progress and
results may be displayed for approximately three
seconds when settings are changed, or during the
process of or after adjustment.

4-4-1 Organization of Viewfinder Screen Status Display

All the items which may be displayed on the
viewfinder screen are located as shown in the figure
below.
2 Lens extender
3 TALK indication
4 D5600K mode
5 Filter
6 White balance memory
7 Gain value
1 Zoom position
Indicates the approximate position of the zoom lens
variator between wide angle (0) and telephoto (99).
Shows how close it is to the telephoto side.
2 Lens extender
"EX" is displayed when a lens extender is in use.
3 TALK indication
Displayed when the intercom microphone is set to ON.
4 D5600K mode
Displayed when D5600K is set to ON.
1 Zoom position
EX Z55
TALK
D 56
1A A 0dB 1/125
W:
About display item selection see "4-6-1 Selecting Display
Items" on page 4-16(E), and about marker display settings
see "4-6-3 Setting Marker Display" on page 4-18(E).
8 Focus position
F255
12.5V 9 Battery voltage
Setting change / adjustment process
message area
This area is only used when the MESSAG
item on the VF DISPLAY page of the
OPERATION menu is set to ON.
F 30 F5.6
-
0 F value
qa Tape remaining
qs Shutter/EVS
5 Filter
Displays the type of filter currently selected. The
number (1, 2, 3, 4, or 5) indicates the ND filter, and the
letter (A, B, C, D or E) is for the CC filter.
6 White balance memory
Displays the currently selected white balance
automatic adjustment memory.
W:A: The WHITE BAL switch is set to "A".
W:B: The WHITE BAL switch is set to "B".
W:P: The WHITE BAL switch is set to "PRST".
Chapter 4 Adjustments and Settings for Recording
4-9(E)