Setting And Adjusting On Setup; Settings For The Intercom Systems - Sony BVP-900 Series System Manual

3-2 Setting and Adjusting on Setup

3-2-1 Settings for the Intercom Systems

The BVP-900-series video camera system can use two
intercom lines, a producer line and an engineer line. It
can also be connected to various intercom systems,
such as 4W, 2W or RTS. Set the internal switches on
Setting the internal switches of the CCU-700A/700AP
Front panel of the internal boards
Selecting the intercom system
Select the intercom system, 2W, 4W or RTS, for each
engineer or producer line.
For the producer line: Set the S2241 (PROD
SELECT) switch on the AT board according to the
intercom system to be used.
For the engineer line: Set the S2491 (ENG SELECT)
switch on the AT board according to the intercom
system to be used.
Factory setting: 4 W
DM
AT
DYNAMIC
CABLE
MIC
OFF
ALARM
SHORT OPEN
CARBON
VA
MAIN CAMERA
POWER POWER
INTERCAM
I I
O O
INTERCOM connector
MIC switch
Component side of the AT board
S2491 switch
S2241 switch
Internal boards of the CCU-700A/700AP
the CCU-700A/700AP/550A/550AP, BVP-900/900P,
and CA-550/550P/570/570P according to the system to
be used.
MIC LEVEL
ENG PROD
CCU REAR INCOM
NORM NORM
PAINT INCOM MIC SELECT
–12 –5 +5 +12
MIN MIN
CLEAR DYNAMIC CARBON ENG I PROD PGM SIDE 2W 2W NTS 2W 2W NTS
CH-1 CH2 PRIVATE
MIX TONE LEVEL CANCEL CANCEL LEVEL CANCEL CANCEL
PGM MIX control
INCOM SELECT switch
S2081
S2081 switch
S2061 switch
S2341
S2061
S2341 switch
S2082 S2082 switch
S2491
S2241
ENG SELECT
PROD SELECT
Notes
• When the RTS system is selected, be sure to connect
the RTS intercom system to this camera system.
Otherwise oscillation may occur.
• When the RTS system is selected, the INTERCOM/
TALLY/PGM connector (19-pin) on the rear panel is
also set for the RTS system, and can be used in the
same manner as the RTS connectors (XLR 3-pin),
however do not use both connectors simultaneously.
3-43
Chapter 3 Initial Settings