Mounting The Ca-905F/905K - Sony BVP-900 Series System Manual

2-1 Mounting the Video Camera

2-1-3 Mounting the CA-905F/905K

Tripod Mounting
Attach the CA-905F/905K to the tripod in the same
manner as attaching the BVP-900/900P.
See "Attaching the hood" in "2-1-1 Mounting the BVP-900/
900P."
Attaching a large-lens for studio use
1
Loosen the lens lock holding knob and turn the
lens lock counterclockwise.
Front cover
Lens lock
Note
Make sure the camera mount is all the way back. If it
is in the forward position, it will be impossible to turn
the lens lock.
2
Remove the front cover of the lens attachment
section.
3
Insert the pin on the rear of the lens into the U-
shaped notch on the front of the unit, and catch the
lens edge on the projection of the unit.
2-18
Chapter 2 Setup
Lens lock
holding knob
Pin
Lens edge
U-shaped notch
Projection
4
Push the rear face of the lens onto the front face of
the unit. Turn the lens lock clockwise so that it
holds down the tongue-like protrusion at the lens
bottom, and tighten the lens lock holding knob.
Lens mode switch
Lens lock and lens lock holding knob
Notes
• Do not use lens ID:F. If the lens ID number is set to
F, change it to another ID number. For details on
verifying or changing the ID number of the lens,
refer to the instruction manual of the lens.
• If you use a serial communication lens, more lens
data can be captured by the camera by switching the
lens mode switch to SERIAL. Normal lens
operation is also possible with the switch set to
NORMAL.
5
Remove the lens cap.