Honda Civic 1998 Service Manual page 999

Trunk Lid/Hatch
Weatherstrip License Plate Trim
Replacement
When installing the trunk lid/hatch weatherstrip, align it
with the alignment mark on the trunk lid/hatch opening.
N O T E :
. Make sure there are no wrinkles in the weatherstrip.
. Check for water leaks.
2D l4Dl
STEEL
CORE
ALIGNMENT
MARK (2Dl4D)
ALIGNMENT MARK
WEATHERSTRIP
ALIGNMENT MARK
BODY
2 0 - 1 0 0
Replacement
CAUTION: Wear gloves to remove and install the license
plate trim.
NOTE: Take care not to scratch the trunk lid/hatch.
1. Remove the ljcense plate.
2.
3D: Remove the hatch trim panel (see page 20-63).
3.
Remove the nuts and clips, and detach the clip, then
remove the license plate trim.
NOTE: Take care not to drop the nuts inside the trunk
lid/hatch.
a: Nut locations,2
f f i s x o . a m m I
\Y9l,/ 1.8 N.m {0.18 kstm.l
-
13 tbtfr)
,/
> : C l i p l o c a t i o n s , 3
I
n A
L
I E L
@ t a 9 @
4 .
Installation is the reverse ofthe removal procedure.
NOTE: lf necessary, replace any damaged clips.