Honda Civic 1998 Service Manual page 1377

Troubleshooting
DTC 1-5
CAUTION: Whenever the ignition switch is ON (lll, or
has been turned OFF lor less than three minutes, be
caretul not to bump the SRS unit; the airbag(s) could
accidentally deploy and cause damagc or iniuries.
DRIVER'S AIRAAG
2P CONNECTOR
DRIVER'S AIRBAG
ASSEMBLY
a
%..
\ \ sRs sERvrcE
\,/
CoNNECTOR t2 0l
07TAZ - 5250200
SRS MAIN HARNESS
2P CONNECTOR
CABLE
REEL
2P CONNECTOR
^P*---.-
( -,
sRs sERvrcE
coNNECTOR
t2 0t
07TAZ - 5250200
SRS SIMULATOR
LEAD C
07TAZ - SZ5011A
and SRS INFLATOR
SIMULATOR
{2 0 JACK)
07sAz - TB4o11A
TrV to reproduce tho SRS indicator lightl
1. Erase the DTC memory (See page 24 15).
2. Turn the ignition switch ON {ll), and check that the SRS indi,
cator light comes on for about six seconds and goes off.
Do6s the SRS indicator liqht 3tev on?
lmehittent tailure, svstem is OK at tfiis timc. See lrouble-
Intermittent Failures on Daqe 24-15.
Check for a short to ground in the driver's airbag intlator:
1. Turn the ignition switch OFF.
2. Disconnect the battery negative cable, then disconnect
the positive cable, and wait for three minutes.
3. Disconnect the driver's airbag 2P connector from the
cable reel 2P connector.
CAUTION: Do not disconnocl the passangei'3 airbag
connoctot,
4. Connect the special tool (2 0) to the cable reel 2P connec,
tor.
5. Reconnect the battery positive cable, then reconnect the
negative cable.
6. Erase the DTC memory (see page 24-15).
7. Read the DTC {see page 24,13).
Short lo ground in the ddvo.'s airbag inflator; replace the
Ch6ck for a short to ground in the cable reet:
L Disconnect the battery negative cable, then disconnect
the positive cable, and wait for three minutes.
2. Disconnect the special tool (2 0) from the cable reel 2P
connector,
3. Bemove the dashboard lower cover, and disconnect the
cable reel 2P connector from the SRS main harness.
4. Connect the Special tool (2 O) to the SRS main harness
2P connector (cont'd).
To page 24-49
24-48
\__