Honda Civic 1998 Service Manual page 1049

Blower Unit
2 .
Replacement
NOTE: The blower motor, recirculation control motor
and blower resistor can be replaced without removinq
the blower unit (see next page).
1 . Remove the glove box {see section 20).
Remove the self-tapping screw and the passenger,s
d a s h b o a r d l o w e r c o v e r . R e m o v e t h e b o l t , t h e n u t
and the knee bolster, then remove the five bolts and
the glove box frame.
GLOVE BOX FRAME
Without Air Conditioning
3-a. Remove the wire harness from the heater duct, then
remove the two self-tapping screws and the heater
quct.
tr
tr
6 a ^ t \
z a - t r ,
KNEE
HEATER DUCT
With Air Conditioning
3-b. Remove the evaporator (see page 22-25).
6 x 1 . 0 m m
9.8 N.m
7.2 tbt tll
6 x 1 . 0 m m
9,8 N.m (1.0 kgf.m,7.2 tbtf
Disconnect the connectors from the blower motor,
blower resistor and recirculation control motor.
Remove the wire harness clip from the recirculation
control motor, and release the wire harness from the
clamp on the blower unit. Remove the two mount-
ing bolts, the mounting nut and the blower unit.
9.8 N.m (1.0 kgf.m,
7.2 tbl.ttl
Install in the reverse order of removal. Make sure
that there is no air leakage.
I
: r -
iCIi1,
6 x 1 . 0 m m
9.8 N.m {1.0 kgf m,
7.2 tbf.tr)
6 x l . 0 m m