Honda Civic 1998 Service Manual page 1308

Cruise Control
Control Unit Input Test
SRS components are located in this area. Review the SRS component locations, precautions, and procedu.es in the SRS
section (24) before performing repairs or service.
1. Remove the driver's dashboard lower cover and knee bolster (see section 20).
2. Disconnect the 14P connector from the control unit.
3.
lnspect the connector and socket terminals to be sure they are all making good contact.
lf the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
lf the terminals look OK, make the following input tests at the connector.
-
lf any test indicates a problem, find and correct the cause, then recheck the system.
-
lf all the input tests prove OK, the control unit must be faulty; replace it.
CONNECTOR
CRUISE CONTROL UNIT
" - " 0
Wire side ol female terminals
;--?\
I
2 6
7
I 1 0
1 l
1 2 1 3
l 4
GRN/WHT LTGRN/RED LT GRN/BLK
BRN/BLK BLU/WHT
LT GRN