Honda Civic 1998 Service Manual page 1172

lgnition Switch
Test
SRS components are located in this area. Review the
SRS component locations, precautlons, and proceoures
in the SRS section {24) before performing repaars or ser-
vtce.
1. Disconnect the battery negative cable.
2.
Remove the driver's dashboard lower cover and
knee bolster (see section 20).
3,
Disconnect the 5P connector from the under-dash
fuse/relay box and the 7P connector from the main
wire harness.
4. Check for continuity between the terminals in each
switch position according to the table.
[ ] :7P connector
W i r e s i d e o f l e m a l e t e r m i n a l s
BLK/WHT (ST}
WHT (BAT}
7P CONNECTOR
WHT/8LK
YEL {IG2)
BLK/YEL (IGlI
Wire side of female terminals
lf the continuity checks do not agree with the table,
reolace the electrical switch
\
Terminal
,olirton-__\
1
(ACC)
(3)
{ BAT)
E
0 G 1 )
I l \ r Z ,
( 1 )
{ST)
o {LocK)
| (ACC)
o- ---o
lr (oN)
o-
--o
III (START)
o-
---o
Electrical Switch RePlacement
SRS components are locat€d in this area Review the
SRS component locations, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice,
1. Disconnect the battery negative cable.
2.
Remove the driver's dashboard lower cover (see
section 20).
3.
Disconnect the 5P connector from the under-dash
fuse/relay box and the 7P connector from the main
wire harness (see left column).
4.
Remove the steering column covers (see section
171.
5.
Insen the ignition key, and turn it to
"0 (LOCK)".
6.
Remove the two screws and the electrical switch
from the steering lock.
7.
lnstall in the reverse order of removal
23-75