Honda Civic 1998 Service Manual page 1007

Opener Cables
Replacement
NOTE:
. When removing the clips, use a clip remover.
. Take care not to bend the opener cables.
Hood open€r cable:
NOTE: Remove the front bumper (see page 20-94) and
inner fender (see page 20-106).
>: Clip locations
A > , 5
B
@
D , 1
#l
HOOD RELEASE
HANDLE
{see page 20-110)
R o u t e t h e o p e n e r
c a b l e t h r o u g h t h e
h o l e i n t h e b o d y .
Installation is the reverse of the removal procedure.
NOTE:
.
Make sure the hood opener cable is routed and
connected properly.
. Make sure the hood opens properly.
2 0 - 1 0 8
\
Trunk lid/Fuel lid opener cable (2Dli[D):
NOTE: Remove the following parts from the left side of
the vehicle. then pull the carpet back, as necessary {see
page 20-66).
. Rear seat cushion (see pages 20-79, 81)
.
Rear seat side bolster (4D, see page 20-79)
. Rear seat-back {2D, see page 20-81)
. Center pillar lowertrim panel (4D, see page 20-59)
.
Lower anchor bolt from the front seat belt (2D,
page 20-86)
. Side trim (see pages 20-59, 61)
o Seat side trim (4D. see page 20-59)
. Side trim panel (2D. see page 20-61)
. Trunk mat and spare tire lid
. Rear trim panel (see page 20-62)
. Trunk side trim, Japan-produced (see page 20-62)
. Trunk trim panel, UsA-produced (see page 20-62)
>: CliD. cable cushion locations
a > , 4
# l
_ L )
D > , 3
I > , 4 D , r
B
_-__l
\ _,)
c >, 1 {4D)
ffi
E > , 4 D , 1
2D,2