Honda Civic 1998 Service Manual page 1207

)
Rear Bearing RePlacement
1. Pull off the rear bearing.
. Make sure the tips ot the bearing puller jaws are
thin enough to fit between the bearing and the
slip rings.
. Do not reuse the bearing.
SLIP RINGS
BEARING PULLER
Use a hand press to install the new bearing. Apply
pressure only on the inner race to avoid damaging
the bearing.
REAR BEARING
SLIP RING
REAR BEARING
Alternator ReassemblY
1 . P u s h t h e b r u s h e s i n , t h e n i n s e r t a p i n o r d r i l l b i t
(about 1.8 mm diameter) to hold them there
BRUSHES
H e a t t h e r e a r b e a r i n g s e a t i n t h e r e a r h o u s i n g a s
described on page 23-106. After heating, continue
immediately with assembling before the rear bear-
ing seat cools completely.
Put the rear housing/stator assembly and drive-end
housing/rotor assembly together, tighten the four
through bolts and pull out the Pin.
BRUSH ACCESS
REAR
STATOB ASS€MBLY
After assembling the alternator, turn the pulley by
hand to make sure the rotor rotates smoothly and
without noise.
THROUGH BOI,T
* ,
2 3 - 1 0 9