Honda Civic 1998 Service Manual page 717

Transmission
l
Installation
Flush the ATF cooler as described on pages '14-284
a n d 1 4 ' 2 8 5 .
R e m o v e t h e u s e d g r e a s e i n t h e f l y w h e e l h u b c a p
and flywheel splines.
Fill the inside of the flywheel hub cap, and coat the fly
wheel hub splines with Super High Temp Urea Grease
(P/N 08798 - 9002) as shown.
2 .
3 .
SUPER HIGH TEMP
UREA GNEASE
{P/N 08798 - 90021
1.5 - 2.5 g (0.05 - 0.og ozl
4 .
I n s t a l l a n e w s e a l i n g r i n g ( r u b b e r ) o n t h e i n p u t
shaft, and install two 14 x 20 mm dowel pins in the
llywheel housing.
lnstall the flywheel securely on the input shaft, then
installthe starter motor on the flywheel housing.
44 N.m
(4.5 kgf.m.33 lbf.ft)
INPUT SHAFT
STARTER
r t l
I
1 4 x 2 0 m m
DOWEI- PIN
S E A L I N G R I N G
{ R U B B E R )
14 x 20 mm DOWEL PIN
SPLINES
Apply SUPER HIGH TEMP
UREA GREASE
{P/N 08798 - 90021
14-280
FLYWHEEL
MOUNT
6.
Place the transmission on a jack, and raise it to the
e n g i n e a s s e m b l y l e v e l .
7. Attach the transmission on the engine, then install
t h e t r a n s m i s s i o n h o u s i n g m o u n t i n g b o l t a n d r e a r
e n g i n e m o u n t i n g b o l t s .
MOUNTING BOLT
64 N.m (6.5 kgt.m,
TRANSMISSION HOUSING
REAR ENGINE MOUNTING
BOLT
Replace.
'12 x 1,25 mm
59 N.m (6.0 kgf.m, 43 lbtftl
WASHER
41
.:_11
12 x L25 mm
74 N.m {7.5 kgl.m, 54lbtft}
8 .
lnstall the transmission mount bracket Tighten the
long bolt loosely, and tighten the nuts and bolt on
t h e m o u n t b r a c k e t t o t h e s p e c i f i e d t o r q u e . T h e n
tighten the long bolt to the specified torque.
1 2 x 1 . 2 5 m m
64 N.m {6.5 kgl.m, 47 lbl.ft)