Honda Civic 1998 Service Manual page 1240

Integrated Control Unit
Input Test
SRS components are located in this area. Review the SRS component locations, precautions, and procedures an the SRS
section (24) before performing repairs or service.
1. Remove the driver's dashboard lower cover and knee bolster (see section 20).
2. Disconnect the 10P connector from the integrated control unit.
3. Remove the integrated control unit from the under-dash fuse/relav box.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
. lf the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
. l f t h e t e r m i n a l s l o o k o K , m a k e t h e f o l l o w i n g i n p u t t e s t s a t t h e c o n n e c t o r a n d t h e f u s e / r e l a y b o x s o c k e t .
-
lf any test indicates a problem, find and correct the cause, then recheck the system.
-
lf all the input tests prove OK, the control unit must be faulty; replace it.
INTEGRATEO CONTROL UNIT
1OP CONNECTOR
Wire side of
female terminals
23-142