7 .
Remove the dashboard (see section 20).
Remove the heater duct (see page 21-16) or evapo-
rator (see page 22-251.
Disconnect the connector from the mode control
motor, and remove the wire harness clips and wire
harness Jrom the heater unit. Remove the clip from
the heater duct, then remove the two mounting
nuts and the heater unit.
6 x 1 . 0 m m
9.8 N m 11.0 kgf'm, 7.2 lblft)
TER DUCT
HEATER UN]T
lnstall in the reverse order of removal. Make note oi
the following items.
Apply sealant to the grommets.
Do not interchange the inlet and outlet heater
hoses. Make sure that the clamps are secure.
R e f i l l t h e c o o l i n g s y s t e m w i t h e n g i n e c o o l a n t
(see section 101.
Connect all cables, and make sure they are prop-
erly adjusted (see page 21-23).
Make sure that there is no air leakage.
8 .
9.
a
a
21-19