f
Gable Reel
Replacement (cont'd)
NOTE:
. B e f o r e i n s t a l l i n g t h e s t e e r i n g w h e e l , t h e f r o n t
wheels should be aligned straight ahead.
. Be sure to lnstall the harness wires so that they
are not pinched or interfering with other parts.
. After reassembly, confirm that the wheels are
still turned straight ahead and that the steering
wheel spoke angle is correct (road test). lf minor
spoke angle adjustment is necessary, do so only
by adjusting the tie-rods, not by removing and
repositioning the steering wheel.
1 1 . S e t t h e c a n c e l s l e e v e s o t h a t t h e p r o i e c t i o n s a r e
aligned venically.
CANCEL
SLEEVE
PROJECTIONS
12. Carefully install the cable reel on the steering col
u m n s h a f t . T h e n c o n n e c t t h e 3 p c o n n e c t o r t o t h e
cable reel sub-harness, and connect the 2p connec-
tor to the SRS main harness.
SRS MAIN HARNESS
€o'1
: _ - - - - - - -
- - - - - - <
r 3 ,
1 4 .
Install the steering column covers.
lf necessary, center the cable reel. (New replacement
cable reels come centered.) Do this by first rotating the
cable reel clockwise until it stops. Then rotate it coun-
terclockwise (approximately two and a half turns) until
the arrow mark on the cable reel label points straight
uD.
ARROW MARK
1 5 . I n s t a l l t h e s t e e r i n g w h e e l , t h e n c o n n e c t t h e h o r n
connector and cruise control sevresume switch con_
neclor.
STEERING WHEEL
CRUISE CONTROL
SET/RESUME