Honda Civic 1998 Service Manual page 1002

Door and Side Moldings
Replacement
CAUTION: When prying with a tlat tip screwdriver, wrap it with protective tape to prevent damage.
NOTE:
. To remove the front side molding, remove the inner fender (see page 20-106).
. To remove the door molding, remove the door panel (see pages 20 4, 10, l6) and plastic cover.
. To remove the rear side molding, remove the side trim panel (see pages 20-60,61).
. Take care not to bend the door moldings.
.
Before .eassembling, clean the door bonding surface with a sponge dampened in alcohol.
. After cleaning, keep oil, grease and water from getting on the surface
. lf necessary, replace any damaged clips.
4D:
2Dl3Dl
c > . 2
REAR SIDE
MOLDING
a: Plastic nut location, 1
@)
(cont'd)
20-103
>: Clip locations
A >: ,lO, 11
2013r),7
B > , 3
_/