Honda Civic 1998 Service Manual page 1234

A/T Gear Position Indicator
Indicator Input Test
1 .
Remove the gauge assembly from the dashboard (see page 23-1'19), and disconnect the t4p connector from rne gauge
assembly.
Inspect the connector and socket terminals to be sure they are all making good contact.
. lf the terminals are bent, loose or co rroded, repa ir lhem as necessary, a nd recheck the system.
. lf the terminals look OK, make the following input tests at the 14p connector.
-
lf a test indicates a problem, find and correct the cause, then recheck the system.
-
lf all the input tests prove OK, but the indicator is faulty, replace the printed circuit board.
14P CONNECTOR "A"
YEL RED/BLK RED
BLU
BRN (*1I
A 1
A2
A3
A 6
A8 A9 A 1 0 A 1 1 412 4 1 3 4 1 4
BLK
WHT LT
GAUGE ASSEMBLY
*1i Not used
'2: Excepr CVT
*3: CvT
23-136