ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Remove the step floor (page 2-9).
Drain the engine oil (page 3-11).
Drain the coolant from the system (page 6-7).
Remove the bolt and disconnect the ground cable.
Remove the rear brake arm adjusting nut, joint pin
and spring
Remove the brake cable from the belt case groove.
Disconnect the ECT sensor connector, throttle posi-
tion sensor 3P (G) connector and SE valve 2P (Bl)
connector.
Remove the wires from the clamp.
Disconnect the air supply hose from the cylinder
head cover.
Disconnect the ignition coil connectors and remove
the wire from the wire band.
ECTSENSOR
CONNECTOR
3P CONNECTOR
mmm
CONNECTORS
7-5