Honda Metropolitan CHF50 Service Manual page 175

KICKSTARTER/DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
To prevent loss of Compress the clutch/driven pulley and remove the
tension, do not stopper ring.
compress the
clutch spring more
than necessary to
remove the stopper
ring.
ACAUTION
Do not remove the special tool when the stop-
per ring is removed. If so, some parts may pop
out.
Install the gear puller or equivalent tool and special
tool as shown.
TOOL:
Puller attachment 07YMC-GCS0100
Loosen the clutch spring compressor gradually and
tighten the gear puller gradually.
Repeat this procedure and remove the clutch
assembly from the driven face.
Remove the following:
- Clutch assembly
- Spring collar
- Driven face spring
- Spring seat
- Movable driven face
- Driven face
i PULLER ATTACHMENT
MOVABLE DRIVEN FACE
CLUTCH
ASSEMBLY
CLUTCH DISASSEMBLY
Remove the E-clip and washer.
Remove the clutch shoes and shoe springs.
COLLAR
E-CLIP/WASHER
SHOES
SPRING
9-13