KICKSTARTER/DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Install the driven face spring and spring collar.
Install the clutch assembly while aligning the tab of
the drive plate with the hole of the clutch assembly.
CLUTCH ASSEMBLY
To prevent loss of
tension, do not
compress the
clutch spring more
than necessary to
assemble the
stopper ring.
COLLAR
SPRING
Set the clutch spring compressor over the clutch/
driven pulley assembly and compress the driven
face spring.
TOOL:
Clutch spring compressor
07LME-GZ40200 or
07960-KM1000A
(U.S.A. only)
Align the spline of the driven face with the spline of
the drive plate while compressing the clutch spring
compressor.
Install the stopper ring securely.
Remove the spring compressor from the clutch/
driven pulley assembly.
CLUTCH SPRING COMPRESSOR
INSTALLATION
Install the drive belt into the driven pulley.
Do not get grease on the driven face inside on the
drive shaft splines.
Install the clutch/driven pulley assembly onto the
driveshaft.
CLUTCH/DRIVEN PULLEY
9-18