FINAL REDUCTION
Remove the dowel pins.
Clean any sealant from the transmission case mat-
ing surface.
Remove the thrust washers and countershaft.
Remove the final gear shaft, counter gear and side
washer.
DRIVESHAFT REMOVAL
Remove the driveshaft using the special tools.
TOOL:
Case puller
Remove the driveshaft oil seal and bearing.
If the bearing is left on the driveshaft, remove it with
the special tool.
TOOL:
Universal bearing puller
10-6
DOWEL PINS
COUNTERSHAFT
WASHER
2002 only
COUNTER GEAR
07SMC-0010001
CASE PULLER
BEARING
07931-4630000 or
equivalent
commercially
available in U.S.A.
DRIVESHAFT
FINAL GEAR SHAFT
WASHERS
DRIVESHAFT
OIL SEAL/BEARING
BEARING PULLER