FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Replace the wheel
bearings in pairs.
Replace the wheel
bearing in pairs.
Do not reuse old
bearings.
WHEEL
Check the rim runout by placing the wheel in a tru-
ing stand.
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:
2.0 mm (0.08 in)
WHEEL BEARING
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Remove and discard the bearings if the races do not
turn smoothly, quietly, or if they fit loosely in the
hub.
DISASSEMBLY
Remove the dust seal.
Install the bearing remover head into the bearing.
From the opposite side of the wheel, install the
bearing remover shaft and drive the bearing out of
the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover shaft
07746-0050100
Bearing remover head, 10 mm
07746-0050200
13-7