FRAME/BODY PANELS/EXHAUST SYSTEM
TRIM CLIPS
REMOVAL
Push the center of the trim clip pin.
Remove the trim clip.
INSTALLATION
Raise the center pin by pushing the retaining tabs
back.
Install the trim clip.
Push the center pin until the pin flush with the outer
casing.
FRONT COVER
REMOVAL
Remove the four screws and front cover from the
leg shield.
Disconnect the headlight connector and remove the
front cover.
INSTALLATION
At installation, be Installation is in the reverse order of removal.
careful not to
damage the wire
harness.
CENTER PIN
TRIM CLIP
CENTER PIN
TRIM CLIP
SCREW
TRIM CLIP
CENTER PIN
CONNECTOR
FRONT COVER
2-4