Table of Contents
Advertisement
LUBRICATION SYSTEM
Install the stator base on the crankcase.
NOTE:
• Check that the stator base must be seated on the
crankcase surface (no clearance) before tighten-
ing the bolts. If the stator base is un-seated,
check the oil pump driven shaft and oil pump
driven gear alignment again.
Tighten the four bolts securely.
Install the alternator/starter assembly (page 11-5).
After installation, fill the crankcase with the recom-
mended engine oil (page 3-10) and check that there
are no oil leaks.
4-9
Advertisement
Table of Contents
Troubleshooting
