Honda Metropolitan CHF50 Service Manual page 286

LIGHTS/METERS/SWITCHES
All the turn signal lights do not operate.
1. Turn Signal Relay Inspection
Remove the front cover (page 2-4).
Disconnect the turn signal relay connector.
Using the jumper wire, short the Black and Gray
wire terminals.
Turn the ignition switch to ON, and operate the
turn signal switch.
Does turn signal light up?
NO - GO TO STEP 2.
YES - • Faulty turn signal relay.
• Poorly connected terminal.
2. Turn Signal Switch Inspection
Inspect the turn signal switch for continuity
(page 18-19).
Does continuity exist?
NO - Faulty turn signal switch.
YES - • Open circuit in Black/gray wire of the
turn signal relay.
• Open circuit in the Green/black wire
between the turn signal light and
ECM.
• Faulty ECM.
REMOVAL/INSTALLATION
FRONT
Remove the front meter cover (page 2-12).
Disconnect the turn signal light connectors.
Remove the screw and cover.
Remove the bolt and turn signal light.
Route the wire Install the turn signal light in the reverse order of
harness correctly removal.
(page 1-14).
RELAY
REAR
Remove the body cover (page 2-7).
Remove the wires from the clamp.
Remove the screws and turn signal lights.
Route the wire Install the turn signal lights in the reverse order of
harness correctly removal.
(page 1-14).
18-6