Panasonic FP-X0 L14R User Manual page 276

Error
Name
code
Compile
E6 memory full
error
High-level
E7 instruction
type error
High-level
instruction
E8 operand
combina-
tion error
No
E9 program
error
Rewrite
during
E10 RUN
syntax
error
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Opera-
tion Description and steps to take
status
The program is too large to compile in the
program memory.
⇒ Change to PROG. mode and reduce the
total number of steps for the program.
Stops
-FP10SH
If memory expansion is possible, compilation
will become possible when the memory is
expanded.
In the program, high-level instructions, which
execute in every scan and at the leading
edge of the trigger, are programmed to be
triggered by one contact. (e.g. F0 (MV) and
Stops
P0 (PMV) are programmed using the same
trigger continuously.)
⇒ Correct the program so that the high-level
instructions executed in every scan and only
at the leading edge are triggered separately.
There is an incorrect operand in an
instruction which requires a specific
Stops
combination of operands (for example, the
operands must all be of a certain type).
⇒ Enter the correct combination of operands.
Program may be damaged.
Stops
⇒Try to send the program again.
When inputting with the programming tool
software, a deletion, addition or change of
Conti-
order of an instruction(ED, LBL, SUB, RET,
nues INT, IRET, SSTP, and STPE) that cannot
perform a rewrite during RUN is being
attempted. Nothing is written to the CPU.
A A A A A A
A A A A A
A A A A A A A
A
A: Available
A A
A A
A A
A A
A A