Panasonic FP-X0 L14R User Manual page 113

6.7.2 Setting Communication Parameters
Settings for baud rate and communication format
The settings for baud rate and communication format of the COM port are entered using a programming
tool.
Setting with FPWIN GR
Select "Options" in the menu bar, and then select "PLC Configuration". Click the "COM Port" tab.
Dialog box of PLC system register setting
No. 410 Unit number
The unit number can be set within a range of 1 to 99.
No. 412 Communication mode
Click on , and select "MODBUS RTU link".
No. 413 Communication Format setting
The default setting of communication format is as below.
Set the communication format to match the external device connected to the communication port.
(The terminator and header cannot be changed.)
Char. Bit: 8 bits
Parity: Odd
Stop Bit: 1 bit
Terminator: Setting disable
Header: Setting disable
No. 415 Baud rate setting
The default setting for the baud rate is "9600 bps". Specify the value to match the connected external
device. The settings of the baud rate switches on the side of the unit and the system register No. 415
should be the same.
6-49
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com