Panasonic FP-X0 L14R User Manual page 225

WR904 FP-X0
Address
R9040 TOOL port mode flag
R9041 COM1 port PC(PLC) link flag
R9042 Not used
R9043 Not used
COM1 port SEND/RECV
R9044
instruction execution flag
COM1 port SEND/RECV
R9045 instruction execution end
flag
R9046 to
Not used
R904F
Note) R9040 to R904F can be changed during 1 scan.
WR905 FP-X0
Address
MEWNET-W0
R9050 PC(PLC) link transmission
error flag
R9051 to
Not used
R905F
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
Goes on when the general-purpose serial
-
communication is used.
Goes off when the MEWTOCOL is used.
-
Turn on while the PC(PLC) link function is used.
-
-
Monitors whether the F145 (SEND) or F146 (RECV)
instructions can be executed or not for the COM1 port.
Off: None of the above mentioned instructions can be
On: One of the above mentioned instructions can be
Monitors if an abnormality has been detected during the
execution of the F145 (SEND) or F146 (RECV)
instructions for the COM1 port as follows:
Off: No abonormality detected.
On: An abnormality detected. (communication error)
-
Name
When using MEWNET-W0
Turns on when a transmission error occurs at PC(PLC)
-
link.
Turns on when there is an error in the PC(PLC) link
-
area settings.
-
Description
executed. (During executing the instruction)
executed.
The error code is stored in DT90124.
Description