Panasonic FP-X0 L14R User Manual page 279

Error
Name
code
MEWNET-F
slave I/O
E38 terminal
mapping
error
IC card read
E39
error
E40 I/O error
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Opera-
tion Description and steps to take
status
I/O mapping for remote I/O terminal
boards, remote I/O terminal units and I/O link
is not correct.
Stops
⇒Re-configure the I/O map for slave stations
according to the I/O points of the slave
stations.
When reading in the program from the IC
memory card(due to automatic reading
because of the dip switch setting or program
switching due to F14(PGRD) instruction):
- IC memory card is not installed.
- There is no program file or it is damaged.
- Writing is disabled.
Stops
- There is an abnormality in the
AUTOEXEC.SPG file.
- Program size stored on the card is larger
than the capacity of the CPU.
⇒Install an IC memory card that has the
program properly recorded and execute the
read once again.
Abnormal I/O unit.
FPΣ, FP-X:
Check the contents of special data register
DT90002 and abnormal FPΣ expansion unit
(application cassette for FP-X). Then check
the unit.
FP2, FP2SH:
Check the contents of special data registers
Sele-
DT90002,DT90003 and abnormal I/O unit.
ctable
Then check the unit.
Selection of operation status using system
register21:
-to continue operation, set 1
-to stop operation, set 0
Verification is possible in FPWIN GR/Pro at
"I/O error" in the status display function.
A A A
A A
A A A A A
A
A: Available