Panasonic FP-X0 L14R User Manual page 21

○
RUN/PROG. mode switch
3
This switch is used to change the operation mode of the PLC.
Switch position
RUN (upward)
PROG. (downword)
• The remote switching operation from the programming tool is operable.
• When performing remote switching from the programming tool, the setting of the mode switch and the
actual mode of operation may differ. Verify the mode with the status indicator LED.
• Restart FPΣ to operate in the mode set with the RUN/PROG. mode switch.
○
COM port baud rate switch
4
This switch is used to change the baud rate of the COM port between 115200 bps and 19200 bps.
Position of switch: On the left side; 115200 bps, On the right side; 19200 bps
○
Tool port (RS232C)
5
This connector is used to connect a programming tool.
A commercial mini-DIN 5-pin connector is used for the tool port on the control unit.
- The followings are the default settings when the unit is shipped from the factory. The system register
should be used to change them.
Baud rate: 9600bps, Char. Bit: 8 bits, Parity check: Odd parity, Stop bit: bit
Note) The unit number of the tool port should be set by the system register.
○
Analog input connector (L40R, L40MR, L60R and L60MR types)
6
Connector for connecting an analog input cable.
○
COM port terminal (RS485: L40MR and L60MR types)
7
It is connected for using RS485 communication. Solderless terminals for M3 are used for connection. As
for the terminal unit, short-circuit the terminals of "E" and "-".
○
Service power supply for input (L30R, L40R, L40MR, L60R and L60MR types)
8
24 VDC power supply that can be used for the input circuit is output. Solderless terminals for M3 are
used for connection.
○
Output circuit terminal block
9
Terminals for output circuit. Solderless terminals for M3 are used for connection.
○
Expansion cover
10
It is removed/installed when installing the expansion cable and backup battery.
○
Input circuit terminal block
11
Terminals for input circuit. Solderless terminals for M3 are used for connection.
○
Power supply terminal block
12
Power supply terminals for driving the PLC internal circuit. A solderless terminal for M3 can be used.
○
DIN rail attachment lever
13
This lever enables the units to attach to a DIN rail at a touch.
○
Expansion connector (L40R, L40MR, L60R and L60MR types)
14
Connector for connecting the expansion I/O unit and expansion FP0 adapter.
○
Space and connector for installing battery (L40R, L40MR, L60R and L60MR types)
15
It is used for installing an optional backup battery.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
This sets the RUN mode. The program is executed is executed and operation
begins.
This sets the PROG. mode. The operation stops.
Pin No. Signal name
1 Signal Ground
2 Send Data
3 Receive Data
4 (Not used)
5 +5V
Operation mode
Abbreviation Signal direction
SG
Unit → External device
SD
Unit ← External device
RD
−
Unit → External device
+5V
−
−