Panasonic FP-X0 L14R User Manual page 275

14.4.1 Table of Syntax Check Error
Error
Name
code
Syntax
E1
error
E2 Duplicated
(Note)
output error
Not paired
E3
error
Parameter
E4 mismatch
error
E5 Program
(Note)
area error
Note) This error is also detected if you attempt to execute a rewrite containing a syntax error during RUN.
In this case, nothing will be written to the CPU and operation will continue.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Opera-
tion Description and steps to take
status
A program with a syntax error has been
written.
Stops
⇒ Change to PROG. mode and correct the
error.
Two or more OT(Out) instructions and
KP(Keep) instructions are programmed using
the same relay. Also occurs when using the
same timer/counter number.
⇒ Change to PROG. mode and correct the
Stops
program so that one relay
is not used for two or more OT instructions. Or,
set the duplicated output to "enable" in system
register 20. A timer/counter instruction double
definition error will be detected even if double
output permission has been selected.
For instructions which must be used in a pair
such as jump (JP and LBL), one instruction is
either missing or in an incorrect position.
Stops
⇒ Change to PROG. mode and enter the two
instructions which must
be used in a pair in the correct positions.
An instruction has been written which does not
agree with system register settings. For
example, the number setting in a program does
Stops not agree with the timer/counter range setting.
⇒ Change to PROG. mode, check the system
register settings, and change so that the
settings and the instruction agree.
An instruction which must be written in a
specific area (main program area or
subprogram area) has been written to a
Stops different area (for example, a subroutine SUB
to RET is placed before an ED instruction).
⇒ Change to PROG. mode and enter the
instruction into the correct area.
A A A A A A A
A A A A A A A
A A A A A A A
A A A A A A A
A A A A A A A
A: Available
A A
A A
A A
A A
A A