Cisco Catalyst 3560-X Command Reference Manual page 788

show storm-control
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-756
Downloaded from www.Manualslib.com
This is an example of output from the show storm-control command for a specified interface. Because
no traffic-type keyword was entered, the broadcast storm control settings appear.
Switch> show storm-control gigabitethernet 1/0/1
Interface Filter State
--------- -------------
Gi1/0/1 Forwarding
Table 2-48 describes the fields in the show storm-control display.
Table 2-48 show storm-control Field Descriptions
Field Description
Interface Displays the ID of the interface.
Filter State Displays the status of the filter:
•
•
•
Upper Displays the rising suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Lower Displays the falling suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Current Displays the bandwidth usage of broadcast traffic or the specified traffic type
(broadcast, multicast, or unicast) as a percentage of total available
bandwidth. This field is only valid when storm control is enabled.
Command Description
storm-control Sets the broadcast, multicast, or unicast storm control levels for the switch.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
Upper Lower
---------- ---------
20 pps 10 pps
Blocking—Storm control is enabled, and a storm has occurred.
Forwarding—Storm control is enabled, and no storms have occurred.
Inactive—Storm control is disabled.
Current
---------
5 pps
OL-21522-02