Cisco Catalyst 3560-X Command Reference Manual page 243

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Examples
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
• tengigabitethernet stack member/module/{first port} - {last port}, where module is always 0
For physical interfaces:
– stack member is the number used to identify the switch within the stack. The number ranges
from 1 to 9 and is assigned to the switch the first time the stack member initializes.
– module is always 0
the range is type stack member/0/number - number (for example, gigabitethernet1/0/1 - 2)
–
port-channel port-channel-number - port-channel-number, where port-channel-number is from 1
•
to 48
Note When you use the interface range command with port channels, the first and last port
channel number in the range must be active port channels.
When you define a range, you must enter a space between the first entry and the hyphen (-):
interface range gigabitethernet1/0/1 -2
When you define multiple ranges, you must still enter a space after the first entry and before the
comma (,):
interface range gigabitethernet1/0/1 - 2, gigabitethernet1/0/1 - 2
You cannot specify both a macro and an interface range in the same command.
You can also specify a single interface in port-range. The command is then similar to the interface
interface-id global configuration command.
For more information about configuring interface ranges, see the software configuration guide for this
release.
This example shows how to use the interface range command to enter interface-range configuration
mode to apply commands to two ports:
Switch(config)# interface range gigabitethernet1/0/1 - 2
Switch(config-if-range)#
This example shows how to use a port-range macro macro1 for the same function. The advantage is that
you can reuse macro1 until you delete it.
Switch(config)# define interface-range macro1 gigabitethernet1/0/1 - 2
Switch(config)# interface range macro macro1
Switch(config-if-range)#
Command
define interface-range
show running-config
manuals search engine
Description
Creates an interface range macro.
Displays the operating configuration. For syntax information, use this link
to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Catalyst 3750-X and 3560-X Switch Command Reference
interface range
2-211