Cisco Catalyst 3560-X Command Reference Manual page 872

spanning-tree uplinkfast
Examples
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-840
Downloaded from www.Manualslib.com
Do not enable the root guard on interfaces that will be used by the UplinkFast feature. With UplinkFast,
the backup interfaces (in the blocked state) replace the root port in the case of a failure. However, if root
guard is also enabled, all the backup interfaces used by the UplinkFast feature are placed in the
root-inconsistent state (blocked) and prevented from reaching the forwarding state.
If you set the max-update-rate to 0, station-learning frames are not generated, so the spanning-tree
topology converges more slowly after a loss of connectivity.
This example shows how to enable UplinkFast:
Switch(config)# spanning-tree uplinkfast
You can verify your setting by entering the show spanning-tree summary privileged EXEC command.
Command
show spanning-tree summary
spanning-tree vlan root primary
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
Description
Displays a summary of the spanning-tree interface states.
Forces this switch to be the root switch.
OL-21522-02