Show Stack-Power - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

show stack-power

Note
Syntax Description
Command Modes
Command History
Usage Guidelines
Examples
OL-21522-02
Downloaded from www.Manualslib.com
To display the members of all StackPower stacks or the specified power stack and the power mode of the
stack, use the show stack-power user EXEC command.
show stack power [stack-id] [ | {begin | exclude | include} expression]
This command is available only on Catalyst 3750-X switch stacks running the IP base or IP services
image.
stack-id
| begin
| exclude
| include
expression
User EXEC
Release
12.2(53)SE2
If a switch is shut down because of load shedding, the output of the show stack power command still
includes the MAC address of the shut down neighbor switch. The command output shows the stack
power topology even if there is not enough power to power a switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
This is an example of output from the show stack-power command.
Switch# show stack-power
Power stack name: Powerstack1
Master MAC address: 0022.bdcf.af80
Stack mode: Power sharing
Switch 1:
Power budget: 206
Low port priority value: 11
High port priority value: 10
Switch priority value: 1
Port A status: Not shut
Port B status: Not shut
Neighbor on port A: 0022.bdcf.ab00
Neighbor on port B: 0022.bdd0.6e00
manuals search engine
(Optional) Display power information for the specified power stack. The
stack ID must be 31 characters or less.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
show stack-power
2-753