Debug Ilpower - Cisco Catalyst 3560-X Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug ilpower

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the debug ilpower privileged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the no form of this command to disable debugging.
debug ilpower {cdp | controller | event | ha | port | powerman | registries}
no debug ilpower {cdp | controller | event | ha | port | powerman | registries}
cdp
controller
event
ha
port
powerman
registries
Debugging is disabled.
Privileged EXEC
Release
12.2(53)SE2
This command is supported only on PoE-capable switches.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command
show controllers power inline
show power inline
manuals search engine
Display PoE Cisco Discovery Protocol (CDP) debug messages.
Display PoE controller debug messages.
Display PoE event debug messages.
Display PoE high-availability messages.
Display PoE port manager debug messages.
Display PoE power management debug messages.
Display PoE registries debug messages.
Modification
This command was introduced.
Description
Displays the values in the registers of the specified PoE controller.
Displays the power status for the specified PoE port or for all PoE
ports.
Catalyst 3750-X and 3560-X Switch Command Reference
debug ilpower
B-15