Debug Backup - Cisco Catalyst 3560-X Command Reference Manual

debug backup

debug backup
Syntax Description
Command Default
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-6
Downloaded from www.Manualslib.com
Use the debug backup privileged EXEC command to enable debugging of the Flex Links backup
interface. Use the no form of this command to disable debugging.
debug backup {all | errors | events | vlan-load-balancing}
no debug backup {all | errors | events | vlan-load-balancing}
all Display all backup interface debug messages.
errors Display backup interface error or exception debug messages.
events Display backup interface event debug messages.
vlan-load- Display backup interface VLAN load balancing.
balancing
Backup interface debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug backup command is the same as the no debug backup command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command
show debugging
manuals search engine
Appendix B
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02